ASPIS · Puzzle solutions

Check both power circuits. One sphere is not enough: use PEP-01 to bring the second energy sphere, install it in the empty circuit and run the door check again.

In the green sector, open the biomaterial supply in the technical compartment and insert both containers into the synthesizer. Set the left fill level to 60% and the right to 40%, then confirm. Load the prepared mixture into the mixer and collect the new energy sphere. Restore the Splitter, then start it.

Find the small red-marked thermal charges in the laboratory. Place a charge into a biomass heart, then move clear before it explodes. Clear the hearts blocking the route; do not stay beside the charge while the Guardian approaches.

When the objective is to overload the core: 1. Set the lever to A while the HF correction angle is below 50°. 2. Once the protective phase activates, set the lever to C while the angle is above 160°. The second violation breaks containment. Exactly 50° or 160° does not meet these conditions.

For the mainline emergency above 140% pressure, close VALVE 1 and VALVE 2 first. Then lower the pipeline lever to release pressure manually. Return to the control room to unlock the airtight gates.

The senior launch engineer took the P-1 key to the relay room to check the second unit. Follow that lead, obtain the key and return to the ASPIS control center to prepare the launch.

At the laboratory door on the institute’s third floor, enter 205 on the keypad: 2 → 0 → 5. This code opens that laboratory door.